Lusitania launching.

KenLin39
5th April 2006, 23:11
Hi All, I've just watched a shipping video (Liners at War), in one section it shows the launch of Lusitania and she had no propellors fitted, was this normal practice, if so why. Cheers. Ken.

Sebe
5th April 2006, 23:28
Hi Ken,

THe website http://www.maritimequest.com/liners/lusitania_page_1.htm
shows the launch of the vessel with the props fitted - which is correct?

Sebe

Bruce Carson
5th April 2006, 23:53
There was a series of reprints of special editions of "The Shipbuilder" published by Patrick Stephens in the 1970s. Thse editions were originally published to commerate the launching of an especially notable ship or sister ships.
Volume two detailed the building of the 'Lusitania' and 'Mauretania'.
There is a full page broadside view of the 'Lusitania' on the stocks with the propellers installed. The caption: "Lusitania" on the Stocks ready for launching".
There is also another view from the stern with the caption "Stern View of the "Lusitania" on Stocks, showing the Propellers, &c.

Bruce C.

KenLin39
6th April 2006, 02:24
Hi Bruce and Sebe, thanks for the info, lounge is all battened down now (alarm set). Will view the video again later, I was probably nodding. Cheers. Ken @ Tilbury.

KenLin39
7th April 2006, 02:15
Hi, thanks for the correction, the video shows a German liner being launched prior to ww1 having 4 shafts but no props. Not named. Ken.

fred henderson
7th April 2006, 12:09
Ken.
The complicated bit in this area of shipbuilding is fitting the propeller shaft, not the propeller. I will try to describe the process in simple terms
The shaft is made from very special steel. It arrives at the shipyard slightly over diameter and is turned down to the precise size in a very large lathe.
In the meanwhile the shaft brackets and their bearings, the stern tube bearing and the shaft tunnel bearings are all installed in the ship. The centre line of the shaft is then established (By laser today, by measurement and a wire in the past) A shaft-boring machine is then assembled at the stern of the ship. This is a shipyard specific tool, consisting of an electric motor and support brackets attached to the end of a long shaft, which is inserted into the precise centre of the line of bearings where the propeller shaft will sit. A sliding cutting head is attached and the inboard end of the cutting shaft supported. The fitters then bore out each of the bearings along the line of the propeller shaft. The newly machined shaft is then slid into position and secured.
The installation of the propeller shafts is probably the most highly skilled machining activity routinely undertaken by shipyard fitters. By contrast fitting the propellers is a muscle job. In answer to your question Ken, the propellers are usually fitted prior to launch. It is quicker as there is more room on the building berth than there is in a dry dock; it avoids corrosion to the exposed shaft and it enables the builder to run basin machinery trials at the fitting out berth, prior to pre sea trial dry-docking.

Fred

KenLin39
8th April 2006, 03:02
Thanks for the info Fred, made interesting reading, I've never been near a shipyard, I guess the Germans put the large liner into a drydock to finish the job. Cheers.